This vehicle will not crank over with the key. But will start when i put
power to the ignition side of the starter. I checked the start fuse it
is good.It has power to the start fuse when the key is in crank
position.I Changed the start relay with a known good relay.
2006 Trailblazer 4.2 2006 Envoy 4.2
Customer Concern:
No crank, the starter will not engage when the key is turned to the start position.
Average Reported Mileage:
77912
Tests/Procedures:
1. With the key in the run and start position check for Battery Voltage (B+) at fuse #22 in the under hood fuse block.
2. If there is less than B+ at #22 fuse check for B+ with the key in the
run and start position at connector C201 at the steering column harness
to the I/P harness, at the base of the steering column pin C6 Pink
wire.
3. If there is less than B+ at pin C6, check for B+ at pin D2 Red wire of the same connector.
4. If there is B+ at pin D2 but not at pin C6, replace the ignition switch.
Identifix shows 5 confirmed fixes for this problem, replacing the ignition switch.
I do not even know how I ended up here, but I thought this post was good.
ReplyDeleteI do not know who you are but certainly you're going to a famous blogger if you are not already ;) Cheers!
Feel free to visit my web-site: http://wiki.oxtli.com.mx
Hi, I do think this is a great web site. I stumbledupon it ;) I will return yet again since I book-marked it.
ReplyDeleteMoney and freedom is the greatest way to change, may you be rich and continue to guide other people.
Feel free to visit my website :: wagner paint crew
I blog often and I really thank you for your information.
ReplyDeleteYour article has truly peaked my interest. I am going to take a note of
your site and keep checking for new details about once per week.
I opted in for your RSS feed too.
Also visit my webpage; wagner airless paint sprayers